Laboratories

OAkwood 7-60OO

504 ROUTE 53, MT. TABOR, NEW JERSEY

leads of the parts, unless the parts are at the piiis near the screws that are used for ground points. Fig. 1 gives a typical layout for a 5763 amplifier. The top of a beer can is one of the best materials available for shields as they are usually copper-plated on one side and tin-plated on the other. The tin side takes solder easily and should be used on the side where most of the soldering is to be done. The

Was this article helpful?

0 0

Post a comment